Never one to leave well enough along, I decided that running the aileron wires through the wing such that the wing rod foam covers could be installed easily needed a little work.
As the pictures show I first bent a piece of 1/16 diameter wire about 3/16 wide. I used a Sharpie marking pen to mark the bottom front edge of the wing groove to 'see' where the wire tool would be used. Holding my Dremel tool perpendicular to the wing I cut the new wiring 'slot' in about 30 seconds.
The servo wiring is now clear of the wing rod foam cover with no loss of bending strength in the wing.

Ray DiNoble